![]() I tried changing the default Z height movement between probe attempts from 5mm to 0, which kind of worked (it didn't raise at the end of the sequence but also didn't raise between probing). Sending a G92 Z10 command doesn't allow me to move the Z height any lower, and I don't know how much the Z height raised to begin with. I'm in the middle of trying to fine-tune the z height offset for the probe, so I'm trying to figure out where the instructions for this movement are in the firmware, or at least disable them temporarily while doing the fine tuning. My problem is that when the sequence ends, the z height raises ~5-10mm. I changed all the settings in Marlin to set it up and enable bilinear meshing, and the printer executes the bed meshing perfectly. I've got a cartesian reprap with Marlin 1.1.8, and I've just added an inductive sensor to my extruder carriage for z probing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |